Prius L4-1.8L (2ZR-FXE) Hybrid (2010)
Be sure to read Precaution thoroughly before servicing See: Air Bag Systems/Service Precautions.
2. REMOVE REAR NO. 2 FLOOR BOARD (for Separate Type) See: Body and Frame/Interior Moulding / Trim/Headliner/Service and
Repair/Removal and Replacement/Removal
3. REMOVE REAR DECK FLOOR BOX See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Removal
4. REMOVE REAR NO. 3 FLOOR BOARD See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Removal
5. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning.
6. REMOVE FRONT DOOR SCUFF PLATE See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Removal
7. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP
8. REMOVE REAR DOOR SCUFF PLATE See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Removal
9. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP
10. REMOVE CENTER PILLAR LOWER GARNISH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Removal
11. REMOVE SIDE AIRBAG SENSOR
(a) Check that the power switch is off.
(b) Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Disconnect the connector.
NOTICE:
When disconnecting any airbag connector, take care not to damage the airbag wire harness.
(1) Push and hold the white housing lock, and slide the yellow outer connector locking sleeve.