Prius L4-1.8L (2ZR-FXE) Hybrid (2010)
Installation
REAR SUSPENSION: REAR SHOCK ABSORBER: INSTALLATION
HINT
*
Use the same procedure for the RH side and LH side.
*
The procedure listed below is for the LH side.
1. INSTALL REAR NO. 1 SPRING BUMPER
(a) Install the rear No. 1 spring bumper to the rear shock absorber assembly.
2. TEMPORARILY TIGHTEN REAR SHOCK ABSORBER ASSEMBLY
(a) Insert the upper end of the rear shock absorber assembly with the rear No. 1 spring bumper to the vehicle body.
(b) Temporarily tighten the rear shock absorber assembly to the rear axle beam assembly with the bolt and nut.
NOTICE:
Since the stopper nut is used, turn the bolt.
HINT
Insert the bolt with the threaded end facing the outside of the vehicle.
3. INSTALL REAR SUSPENSION SUPPORT
(a) Install the rear suspension support.
NOTICE:
Make sure that the rear suspension support is correctly installed as shown in the illustration.