RAV4 2WD L4-2.5L (2AR-FE) (2009)
NAVIGATION: NAVIGATION SYSTEM: Touch Panel Switch does not Function
Touch Panel Switch does not Function
INSPECTION PROCEDURE
PROCEDURE
1. CHECK TOUCH PANEL
(a) Check for foreign matter on the display.
OK:
The display is clean.
NG -- CLEAN DISPLAY AND RECHECK TOUCH PANEL
OK -- Continue to next step.
2. CHECK TOUCH SWITCH (DISPLAY CHECK MODE)
(a) Enter the "Display Check" mode and select "Touch Switch Check" See: Initial Inspection and Diagnostic Overview/Operation Check.
(b) Touch the display in the area where the switch malfunction occurs.
OK:
A "+" mark appears at the touched position.
NG -- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE
OK -- REPLACE NAVIGATION RECEIVER ASSEMBLY
Vehicle Position Mark Deviates Greatly
NAVIGATION: NAVIGATION SYSTEM: Vehicle Position Mark Deviates Greatly
Vehicle Position Mark Deviates Greatly
INSPECTION PROCEDURE
PROCEDURE
1. CHECK GPS MARK
(a) Check that the GPS mark is displayed.
OK:
GPS mark is displayed.
NG -- PROCEED TO "GPS MARK IS NOT DISPLAYED"
OK -- Continue to next step.
2. CHECK VEHICLE SENSOR (NAVIGATION CHECK MODE)