RAV4 2WD L4-2.5L (2AR-FE) (2009)
(a) Connect the skid control sensor wire connector (labeled A) to the skid control sensor.
(b) Install the sensor clamp (labeled B) with the bolt (labeled C).
Torque: 8.5 Nm (87 kgf-cm, 75 in-lbf)
NOTE: Do not twist the sensor wire when installing the clamp.
(c) Install the 2 sensor clamps (labeled D) with the 2 nuts (labeled E).
Torque: 5.0 Nm (51 kgf-cm, 44 in-lbf)
NOTE: Do not twist the sensor wire when installing the clamps.
(d) Install the sensor clamp (labeled F) with the bolt (labeled G).
Torque: 8.5 Nm (87 kgf-cm, 75 in-lbf)
NOTE: Do not twist the sensor wire when installing the clamp.