RAV4 2WD L4-2.5L (2AR-FE) (2009)
AXLE: FRONT AXLE HUB BOLT: REPLACEMENT
REPLACEMENT
HINT:
-
Use the same procedures for the RH side and LH side.
-
The procedures listed below are the LH side.
1. REMOVE FRONT WHEEL
2. REMOVE FRONT DISC BRAKE CYLINDER ASSEMBLY LH See: Brakes and Traction Control/Disc Brake System/Service and
Repair/Removal and Replacement/Front Brake/Removal
3. REMOVE FRONT DISC See: Brakes and Traction Control/Disc Brake System/Service and Repair/Overhaul/Front/Disassembly
4. REMOVE FRONT AXLE HUB BOLT
(a) Using SST, remove the hub bolt that needs to be replaced.
SST: 09650-17011
5. INSTALL FRONT AXLE HUB BOLT
(a) Insert a new hub bolt into the bolt hole. Set a plate washer and nut on the hub bolt end.
(b) Using a brass bar or equivalent to hold the front axle, install the hub bolt by tightening the nut. Then remove the nut and plate washer.
6. INSTALL FRONT DISC See: Brakes and Traction Control/Disc Brake System/Service and Repair/Overhaul/Front/Reassembly
7. INSTALL FRONT DISC BRAKE CYLINDER ASSEMBLY LH See: Brakes and Traction Control/Disc Brake System/Service and
Repair/Removal and Replacement/Front Brake/Installation
8. INSTALL FRONT WHEEL
Torque: 103 Nm (1050 kgf-cm, 76 ft-lbf)