RAV4 2WD V6-3.5L (2GR-FE) (2006)
A.
Attach the seal plate (foam block) so that the left end is 30 mm (1.18 in.) from the cut line (point A) on the sheet metal below the windshield
and then move toward the center of the windshield.
B.
Make sure the seal plate (foam block) is fully pressed against the sheet metal under the base of the windshield.
NOTE:
Confirm that the lower cowl panel is properly installed and the seals (circled in red above) are NOT damaged or deformed.
NOTE:
Do NOT leave a gap between the lip and windshield glass.