RAV4 2WD V6-3.5L (2GR-FE) (2006)
Step 11(Continued)-12
INSPECTION PROCEDURE
Check DLC3
CHECK DLC3
The ECU uses ISO 15765-4 for communication. The terminal arrangement of the DLC3 complies with ISO15031-3 and matches the ISO 15765-4
format.
NOTE: *: Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any switches or doors.
If the result is not as specified, the DLC3 may have a malfunction. Repair or replace the harness and connector.
HINT: Connect the cable of the intelligent tester (with CAN VIM) to the DLC3, turn the ignition switch ON and attempt to use the tester. If the display
indicates that a communication error has occurred, there is a problem either with the vehicle or with the tester.
-
If communication is normal when the tester is connected to another vehicle, inspect the DLC3 on the original vehicle.