toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Steering - Pop/Clunk/Knock While Turning|Page 5416 > < A/T - Shift Lever Doesn't Move Smoothly|Page 5410
Page 1
background image

Steering Shaft: All Technical Service Bulletins
Steering - Pop/Clunk/Knock While Turning

T-SB-0318-08

Rev1

October 20, 2008

Steering Intermediate Shaft Noise

Service Category
Steering

Section
Steering Gear/Linkage

Market
USA

Applicability

TSB REVISION NOTICE

^

February 1, 2010 Rev1:

^

The replacement of Steering Intermediate Shaft Assembly No.2 has been eliminated from the bulletin.

^

Parts Information has been updated.

^

The Repair Procedure has been updated.

Any previous printed versions of this service bulletin should be discarded.

TSB SUPERSESSION NOTICE

The information contained in this TSB supersedes TSB No. ST001-08.

^

Applicability has been updated to include 2008 model year vehicles.

^

The Introduction has been updated.

^

A new part (hose clamp, P/N 90460-64003) has been added to the Parts Information table.

^

Steps 3 and 9 of the Repair Procedure have been updated.

TSB No. ST001-08 is Obsolete and any printed versions should be discarded. Be sure to review the entire content of this service bulletin before
proceeding.

Introduction

Steering - Pop/Clunk/Knock While Turning|Page 5416 > < A/T - Shift Lever Doesn't Move Smoothly|Page 5410