RAV4 2WD V6-3.5L (2GR-FE) (2006)
(10)Raise the vehicle and remove the engine undercovers.
1. Remove the 8 plastic clips 8 bolts and the large engine undercover.
2. Remove the 3 plastic clips and the small engine undercover.
3. Lower the vehicle.
(11)Using a hydraulic jack with a rubber pad or wood block gently support the engine/transaxle assembly to remove the load from the bolt and
nut of the engine mounting insulator LH.
(12)Remove the bolt and nut and disconnect the engine mounting insulator LH.
(13)Remove the 4 bolts and engine mounting insulator LH.
(14)Install the NEW engine mounting insulator LH with the 4 bolts.