RAV4 2WD V6-3.5L (2GR-FE) (2006)
/Page-2082002.png)
21. REMOVE NO. 2 WINDSHIELD OUTSIDE MOULDING FASTENER
a. Apply protective tape to the outer surface of the vehicle body to prevent scratches. Using a heat light, heat the moulding to 40 to 60 degrees C
(104 to 140 degrees F).
NOTE: Do not heat the moulding excessively.
b. Tie both piano wire ends to wooden blocks or similar objects.
c. Cut the adhesive tape by pulling the piano wire as shown in the illustration.
d. Remove the 2 clips and moulding fastener.
22. REMOVE NO. 1 WINDSHIELD OUTSIDE MOULDING FASTENER
HINT: Use the same procedures described for the LH side.
23. REMOVE COWL TOP VENTILATOR LOUVER
