RAV4 4-Door 4WD L4-2.0L (3S-FE) (1997)
Remove Union Bolt
1. Disconnect flexible hose.
(a) Remove the union bolt and 2 gaskets from the Caliper, then disconnect the flexible hose from the Caliper.
Torque: 30 Nm (22 ft. lbs.)
NOTE: Install the flexible hose lock securely in the lock hole in the Caliper.
(b) Use a container to catch the brake fluid as it drains out.
2. Remove Caliper.
(a) Hold the sliding pin and loosen the 2 installation bolts.
Torque: 26 Nm (20 ft. lbs.)
(b) Remove the 2 installation bolts.
(c) Remove the Caliper from the torque plate.
3. Remove these parts:
(a) 2 Brake Pads with anti-squeal shims.
(b) 4 pad support plates.
INSTALLATION
Installation is in the reverse order of removal.
NOTE: After installation, fill brake reservoir with brake fluid, bleed brake system. Refer to Brakes - Service and Repair. See: Brake
Bleeding/Service and Repair
Check for leaks.