RAV4 4-Door 4WD L4-2.0L (3S-FE) (1997)
NOTE (When re-using timing belt): Check that the matchmark on the timing belt matches the end of the No. 1 timing belt cover.
If the matchmark does not align, align as follows:
When matchmark is misaligned clockwise:
-
Align the matchmarks by pulling the timing belt up on the water pump pulley side while turning the crankshaft pulley counterclockwise.
-
After aligning the matchmarks, hold the timing belt, turn the crankshaft pulley clockwise, and align its groove with timing mark "0" of the No.
1 timing belt cover.
When matchmark is misaligned counterclockwise:
-
Align the matchmarks by pulling the timing belt up on the No. 1 idler pulley side while turning the crankshaft pulley clockwise.