RAV4 4-Door 4WD L4-2.0L (3S-FE) (1997)
/Page-779001.png)
Knock Sensor: Component Tests and General Diagnostics
COMPONENTS FOR REMOVAL AND INSTALLATION
KNOCK SENSOR INSPECTION
1. 4WD:
REMOVE ENGINE AND TRANSAXLE ASSEMBLY
2. REMOVE KNOCK SENSOR
(a) Disconnect the knock sensor connector.
(b) Using SST. remove the knock sensor.
SST 09816-30010
Torque: 44 N.m (450 kgf.cm, 33 ft.lbf)
3. INSPECT KNOCK SENSOR
Using an ohmmeter, check that there is no continuity between the terminal and body.
If there is continuity, replace the sensor.
4. REINSTALL KNOCK SENSOR
