RAV4 4-Door 4WD L4-2.0L (3S-FE) (1997)
Power Door Lock Relay: Testing and Inspection
INSPECT DOOR LOCK CONTROL RELAY CIRCUIT
Disconnect the connector from the relay and inspect the connector on the wire harness side, as shown in the chart.
If the circuit is not as specified, inspect the circuits connected to other parts.
DOOR LOCK SIGNAL
HINT: When the relay circuit is as specified. inspect the door lock signal.
1. Connect the connector to the relay.
2. Connect the positive (+) lead from the voltmeter to terminal 3 and the negative (-) lead to terminal 4.
3. Set the door lock manual switch to UNLOCK, check that the voltage rises from 0 volts to battery voltage for approximately 0.2 seconds.