RAV4 4-Door 4WD L4-2.0L (3S-FE) (1997)
b. Using Special Service Tool (SST) and a press, install a new bearing into the bearing case.
SST 09950 - 60010 (09951 - 00580), 09950 - 70010 (09951 - 07150)
c. Using a screwdriver, install a new snap ring.
d. Using SST and a press, install the bearing with the bearing case assembly to the center drive shaft.
SST 09710 - 30021 (09710 - 03141)
e. Using a snap ring expander, install a new snap ring.
f.
Using SST, an extension bar and press, install a new dust cover.
SST 09506 - 35010
HINT: The clearance between the dust cover and bearing should be kept in the ranges shown in the illustration.
3. Install dust cover.
RH: Using a steel plate and press, install a new dust cover until the distance from the tip of the center drive shaft to the dust cover reaches the
specification, as shown in the illustration.