Toyota Workshop Service and Repair Manuals

Output Shaft: Specifications

SERVICE SPECIFICATIONS 

1st Gear Journal Diameter:

Minimum ................................................................................................................................................................................  37.526 mm (1.4774 in.)

2nd Gear Journal Diameter:

Minimum ................................................................................................................................................................................  34.512 mm (1.3588 in.)

Runout:

Maximum .....................................................................................................................................................................................  0.6 mm (0.0024 in.)

Output Shaft Bearing Preload (At Starting):

New Bearing ..............................................................................................................................................................  0.8-1.6 N.m (6.9-13.9 inch lbs.)
Reused Bearing ............................................................................................................................................................  0.5-1.0 N.m (4.3-8.7 inch lbs.)

TORQUE SPECIFICATIONS 

Output Shaft Lock Nut .......................................................................................................................................................................  123 N.m (90 ft. lbs.)