RAV4 4WD L4-2.0L (1AZ-FE) (2001)
4. INSTALL FRONT FENDER APRON
HINT: Inspect the fitting of the front fender and hood, etc. before welding, since this affects the appearance of the finish.
a. Temporarily install the new parts and measure each part in accordance with the body dimension diagram.
HINT: Make sure each measurement is correct, as this parts affects the front wheel alignment.
5. MEASURING THE ENGINE COMPARTMENT DIMENSIONS
6. MEASURING THE UNDER BODY DIMENSIONS
7. INSTALL COWL TOP SIDE PANEL
8. INSTALL RADIATOR UPPER SUPPORT
9. APPLYING SEALER TO THE ENGINE COMPARTMENT
10. APPLYING UNDER COATING
11. APPLYING ANTI-RUST AGENT
a. After applying the top coat layer, apply the anti-rust agent to the inside of the necked section structural weld spots.