RAV4 4WD L4-2.0L (1AZ-FE) (2001)
NOTE: The snap ring should be installed so that beveled side faces up.
3. INSTALL PRESSURE PLATE
a. Install the shims to the pressure plate and install the pressure plate on the rotor.
b. Using SST and a torque wrench, install the shaft bolt.
SST 07112-66040, 07112-76060
Torque: 18 N.m (184 kg.cm, 13.2 ft.lb)
4. INSPECT MAGNETIC CLUTCH CLEARANCE
a. Set the dial indicator to the pressure plate of the magnetic clutch.
b. Connect the positive(+) lead from the battery to the terminal 3 and the negative(-) lead to the ground.
c. Check the clearance between the pressure plate and rotor when connecting the negative(-) terminal to the battery.
Standard clearance: