RAV4 4WD L4-2.0L (1AZ-FE) (2001)
5. INSPECT TOE-IN
If the toe-in is not within the specification, adjust it.
6. ADJUST TOE-IN
(a) Remove the boot clips.
(b) Loosen the tie rod end lock nuts.
(c) Turn the left and right rack ends by an equal amount to adjust the toe-in.
HINT:
-
Try to adjust the toe-in to the center of the specified value.
-
Make sure that the length of the left and right rack ends is the same.
Tie rod end length difference: 1.5 mm (0.059 inch) or less
(d) Tighten the tie rod end lock nuts.
Torque: 56 Nm (570 kgf-cm, 41 ft. lbs.)
(e) Place the boot on the seat and install the boot clips.
HINT: Make sure that the boots are not twisted.
7. INSPECT WHEEL ANGLE
Turn the steering wheel fully and measure the turning angle.