RAV4 4WD L4-2.0L (1AZ-FE) (2001)
5. REMOVE REAR AXLE HUB
(a) 2WD:
Disconnect the ABS speed sensor connector.
(b) Remove the 4 nuts and rear axle hub.
Torque: 50 Nm (510 kgf-cm, 37 ft. lbs.)
REPLACEMENT
1. 2WD:
REMOVE ABS SPEED SENSOR
(a) Using a pin punch and a hammer, pull out the 2 pins, and remove the 2 attachments from SST.
SST 09520-00031 (09520-00040, 09521-00020)
(b) Mount the axle hub assembly with a soft jaw vise.
NOTICE: Replace the axle hub assembly if it is dropped or strong shock is given to it.
(c) Using SST and 2 bolts (Diameter: 12 mm, Pitch: 1.5 mm), remove the ABS speed sensor.
SST 09520-00031 (09520-00040, 09521-00020), 09950-00020
NOTICE:
-
Do not allow any foreign objects to stick to the sensor rotor.
-
Pull out the ABS speed sensor straightly in order not to damage the sensor rotor.
-
If the sensor rotor is damaged, replace the axle hub assembly.
-
Do not scratch the contacting surface of the axle hub and speed sensor.