RAV4 4WD L4-2.0L (1AZ-FE) (2001)
d. Temporarily install new terminal 30 kit parts:
1. Install a new terminal insulator (inside).
NOTE: Be careful to install the terminal insulator in the correct direction.
2. Install a new contact plate.
3. Install a new terminal bolt.
4. Install a new O-ring.
5. Install a new packing to anew terminal insulator, and install them.
HINT: Match the protrusion of the insulator with the indentation of the housing.
6. Install a new wave washer.
NOTE: Be careful to install the wave washers in the correct direction.
7. Install a new terminal nut.
Temporarily tighten the terminal nut.
e. Temporarily install new terminal C kit parts:
1. Install a new terminal insulator (inside).
NOTE: Be careful to install the terminal insulator in the correct direction.
2. Install a new contact plate.
3. Install a new terminal bolt.
4. Install a new O-ring.
5. Install a new terminal insulator (outside).
6. Install a new wave washer.
NOTE: Be careful to install the wave washer in the correct direction.
7. Install a new terminal nut.
Temporarily tighten the terminal nut.
f.
Tighten terminal nuts.
1. Put a wooden block on the contact plate and press it down with a hand press.
Dimensions of wooden block: 20 x 37 x 40 mm (0.79 x 1.46 x 1.57 in.)
Press force: 981 N (100 kg, 221 lb)