RAV4 4WD L4-2.0L (3S-FE) (1996)
Fuel Pressure Release: Service and Repair
1. When disconnecting the high fuel pressure line, a large amount of gasoline will spill out, so observe the following procedures:
-
Disconnect the fuel pump connector.
-
Start the engine. After the engine has stopped on its own, turn the ignition switch to LOCK.
-
Put a container under the connection.
-
Slowly loosen the connection.
-
Disconnect the connection.
-
Plug the connection with a rubber plug.
2. When connecting the flare nut or union bolt on the high pressure pipe union, observe the following procedures:
Union Bolt Type:
-
Always use 2 new gaskets.
-
Tighten the union bolt by hand.
-
Tighten the union bolt to the specified torque.
Torque: 29 N.m (300 kgf.cm, 22 ft.lbf)
Flare Nut Type:
-
Apply a light coat of engine oil to the flare nut, and tighten the flare nut by hand.
-
Using SST, tighten the flare nut to specified torque.
SST 09631-22020