RAV4 4WD L4-2.4L (2AZ-FE) (2007)
A description of the main areas of each circuit inspection is given.
Voltage Check
VOLTAGE CHECK
a. Establish conditions in which voltage is present at the check point.
Example:
[A] - Ignition SW on
[B] - Ignition SW and SW 1 on
[C] - Ignition SW, SW 1 and Relay on (SW 2 off)
b. Using a voltmeter, connect the negative lead to a good ground point or negative battery terminal, and the positive lead to the connector or
component terminal.
This check can be done with a test light instead of a voltmeter.
Continuity and Resistance Check
CONTINUITY AND RESISTANCE CHECK
a. Disconnect the battery terminal or wire so there is no voltage between the check points.