RAV4 4WD L4-2.4L (2AZ-FE) (2007)
/Page-1275003.png)
a. Install the coil spring to the suspension No. 2 arm.
3. INSTALL REAR COIL SPRING INSULATOR UPPER LH
a. Align the stopper part of the insulator upper with the coil spring tip, and install the insulator upper.
4. TEMPORARILY INSTALL REAR SUSPENSION NO. 2 ARM ASSEMBLY LH
a. Slowly raise the suspension No. 2 arm with a jack, and connect the suspension No. 2 arm to the axle carrier.
b. Install the bolt and nut.
NOTICE: Install the arm so that the coil spring's distinguishing mark is on the outer side of the vehicle.
5. INSTALL REAR STABILIZER LINK ASSEMBLY LH
6. CONNECT NO. 2 PARKING BRAKE CABLE ASSEMBLY
7. INSTALL SKID CONTROL SENSOR WIRE (for 2WD)
8. INSTALL REAR SPEED SENSOR LH (for 4WD)
9. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
10. STABILIZE SUSPENSION
11. TIGHTEN REAR SUSPENSION NO. 2 ARM ASSEMBLY LH
12. CHECK SPEED SENSOR SIGNAL
a. Check the speed sensor signal.
13. INSPECT AND ADJUST REAR WHEEL ALIGNMENT
a. Inspect and adjust the rear wheel alignment.
