RAV4 4WD L4-2.5L (2AR-FE) (2009)
DOOR LOCK: ENTRY LOCK AND UNLOCK SWITCH (for Front): REMOVAL
REMOVAL
HINT:
-
Use the same procedure for the RH and LH sides.
-
The procedures listed below are for the LH side.
1. REMOVE FRONT LOWER DOOR FRAME BRACKET GARNISH LH See: Body and Frame/Doors, Hood and Trunk/Doors/Front
Door/Service and Repair/Disassembly
2. REMOVE FRONT UPPER ARMREST BASE PANEL LH See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Service and
Repair/Disassembly
3. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Service and
Repair/Disassembly
4. REMOVE FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY LH See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Service
and Repair/Disassembly
5. REMOVE FRONT DOOR SERVICE HOLE COVER LH See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Service and
Repair/Disassembly
6. REMOVE FRONT DOOR OUTSIDE HANDLE COVER LH (for Driver Side) See: Body and Frame/Doors, Hood and Trunk/Doors/Front
Door/Service and Repair/Disassembly
7. REMOVE FRONT DOOR OUTSIDE HANDLE COVER RH (for Passenger Side) See: Body and Frame/Doors, Hood and Trunk/Doors/Front
Door/Service and Repair/Disassembly
8. REMOVE FRONT DOOR OUTSIDE HANDLE ASSEMBLY LH
(a) Disconnect the connector.
(b) Remove the handle by sliding and pulling it in the direction indicated by the arrow in the illustration.
Installation
DOOR LOCK: ENTRY LOCK AND UNLOCK SWITCH (for Front): INSTALLATION
INSTALLATION
HINT:
-
Use the same procedure for the RH and LH sides.
-
The procedures listed below are for the LH side.
-
A bolt without a torque specification is shown in the standard bolt chart See: Specifications/Mechanical Specifications/Standard Bolt -
Specified Torque For Standard Bolts.
1. INSTALL FRONT DOOR OUTSIDE HANDLE ASSEMBLY LH