RAV4 4WD L4-2.5L (2AR-FE) (2009)
(b) Install the bolt to the support.
Torque: 24 Nm (245 kgf-cm, 18 ft-lbf)
2. INSTALL PUSH ROD PIN
(a) Apply lithium soap base glycol grease to the push rod pin.
(b) Install the push rod pin to the push rod clevis.
NOTE: The push rod pin must be installed as shown in the illustration.
(c) Install the clip to the push rod pin.
NOTE: The clip must be installed as shown in the illustration.
3. INSTALL STOP LIGHT SWITCH ASSEMBLY
(a) Insert the switch into the adjuster until the switch body touches the pedal.
NOTE: Do not depress the pedal.
(b) Turn the switch a quarter turn clockwise.