RAV4 4WD L4-2.5L (2AR-FE) (2009)
/Page-1237001.png)
Ignition Relay: Testing and Inspection
Ignition Relay No. 1
2AR-FE ENGINE CONTROL SYSTEM: IGNITION RELAY NO. 1: ON-VEHICLE INSPECTION
ON-VEHICLE INSPECTION
1. INSPECT IG1 RELAY
(a) Remove the IG1 relay from the instrument panel junction block.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
If the result is not as specified, replace the IG1 relay.
(c) Install the IG1 relay to the instrument panel junction block.
