RAV4 4WD L4-2.5L (2AR-FE) (2009)
/Page-53001.png)
Horn Relay: Testing and Inspection
HORN: INTEGRATION RELAY: ON-VEHICLE INSPECTION
ON-VEHICLE INSPECTION
1. REMOVE ENGINE ROOM NO. 1 RELAY BLOCK COVER
2. INSPECT INTEGRATION RELAY (UNIT A: HORN RELAY)
(a) Using a screwdriver, detach the 2 claws and disconnect the integration relay from the engine room junction block.
HINT: Tape the screwdriver tip before use.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
If the result is not as specified, replace the integration relay.
3. INSTALL ENGINE ROOM NO. 1 RELAY BLOCK COVER
