RAV4 4WD L4-2.5L (2AR-FE) (2009)
SUPPLEMENTAL RESTRAINT SYSTEM: FRONT AIRBAG SENSOR: REMOVAL
REMOVAL
CAUTION: Be sure to read the precautionary notices concerning the SRS airbag system before servicing it See: Air Bag
Systems/Service Precautions.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat
belt pretensioner activation.
2. REMOVE RADIATOR SUPPORT OPENING COVER
3. REMOVE FRONT AIRBAG SENSOR LH
(a) Disconnect the sensor connector.
(b) Remove the bolt and sensor.
4. REMOVE FRONT AIRBAG SENSOR RH
(a) Disconnect the sensor connector.
(b) Remove the bolt and sensor.
Installation
SUPPLEMENTAL RESTRAINT SYSTEM: FRONT AIRBAG SENSOR: INSTALLATION
INSTALLATION
CAUTION: Be sure to read the precautionary notices concerning the SRS airbag system before servicing it See: Air Bag
Systems/Service Precautions.
1. INSTALL FRONT AIRBAG SENSOR LH
(a) Install the sensor with the bolt.
Torque: 9.0 Nm (92 kgf-cm, 80 in-lbf)
NOTICE:
-
If the airbag sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.
-
When installing the airbag sensor, make sure that the SRS wiring does not interfere with other parts and is not pinched between other parts.
(b) Check that there is no free play in the installation parts of the sensor.