RAV4 4WD L4-2.5L (2AR-FE) (2009)
/Page-1743002.png)
Standard toe-in (unloaded vehicle):
If the toe-in is not as specified, adjust it at the rack ends.
4. ADJUST TOE-IN
(a) Remove the boot clips.
(b) Loosen the tie rod end lock nuts.
(c) Turn the right and left rack ends by an equal amount to adjust the toe-in to the center value.
(d) Make sure that the length of the right and left rack ends are approximately the same.
Standard difference:
1.5 mm (0.059 in.) or less
(e) Tighten the tie rod end lock nuts.
Torque: 55.5 Nm (566 kgf-cm, 41 ft-lbf)
(f) Place the boots on the seats and install the clips.
HINT: Make sure that the boots are not twisted.
5. INSPECT WHEEL ANGLE
(a) Turn the steering wheel to the left and right full lock positions, and measure the turning angle.
Standard wheel angle (unloaded vehicle):
