RAV4 4WD L4-2.5L (2AR-FE) (2009)
SUSPENSION: REAR UPPER CONTROL ARM: REMOVAL
REMOVAL
HINT:
-
Use the same procedures for the RH side and LH side.
-
The procedures listed below are for the LH side.
1. REMOVE REAR WHEEL
2. DISCONNECT SKID CONTROL SENSOR WIRE (for 2WD)
3. DISCONNECT REAR SPEED SENSOR LH (for 4WD) See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Wheel
Speed Sensor/Service and Repair/Rear Speed Sensor/Removal
4. REMOVE REAR UPPER CONTROL ARM ASSEMBLY LH
(a) Support the No. 2 suspension arm.
(b) Remove the 2 bolts and 2 nuts, and disconnect the upper control arm.
NOTE: When removing the bolts, hold the nuts in place.
Installation
SUSPENSION: REAR UPPER CONTROL ARM: INSTALLATION
INSTALLATION
HINT:
-
Use the same procedures for the RH side and LH side.
-
The procedures listed below are for the LH side.
1. TEMPORARILY INSTALL REAR UPPER CONTROL ARM LH
(a) Temporarily install the control arm with the 2 bolts and 2 nuts.
HINT: Fix the nuts in place and tighten the bolts.
2. CONNECT SKID CONTROL SENSOR WIRE (for 2WD)
3. CONNECT REAR SPEED SENSOR LH (for 4WD) See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Wheel Speed
Sensor/Service and Repair/Rear Speed Sensor/Installation
4. INSTALL REAR WHEEL