RAV4 4WD L4-2.5L (2AR-FE) (2009)
1. INSTALL FRONT DRIVE SHAFT BEARING (for RH)
(a) Install a new snap ring to the inboard shaft.
(b) Using SST and a press, press the drive shaft bearing onto the inboard joint RH.
SST: 09527-10011
SST: 09710-04081
NOTE: Make sure the bearing is completely installed.
(c) Using a snap ring expander, install a new snap ring.
2. INSTALL FRONT DRIVE SHAFT DUST COVER RH
(a) Using SST and a press, press a new drive shaft dust cover onto the inboard joint until the distance shown in the illustration reaches the
specification.
SST: 09527-10011
Standard distance:
104 +/-0.5 mm (4.09 +/-0.02 in.)
NOTE: Be careful not to damage the dust cover.