RAV4 4WD V6-3.5L (2GR-FE) (2006)
a. Pull the lock lever upward and disconnect the connector.
b. Disconnect the brake tube clamp from the bracket.
c. Remove the 3 nuts and actuator with bracket.
NOTE: Be careful not to damage the brake tubes.
INSTALLATION
1. INSTALL ABS AND TRACTION ACTUATOR ASSEMBLY WITH BRACKET
NOTE: Do not remove the hole plug before connecting the brake tube. New actuators are filled with brake fluid.
a. Install the actuator with bracket with the 3 nuts.
Torque: 19 N.m (194 kgf.cm, 14 ft.lbf)