RAV4 4WD V6-3.5L (2GR-FE) (2006)
Door Switch: Service and Repair
Rear Door Courtesy Switch
REMOVAL
HINT:
-
Use the same procedures for the RH and LH sides.
-
The procedures listed below are for the LH side.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt
pretensioner activation.
2. REMOVE REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY
a. Remove the bolt and switch.
b. Disconnect the connector.
INSTALLATION
HINT:
-
Use the same procedures for the RH and LH sides.
-
The procedures listed below are for the LH side.
-
A bolt without a torque specification is shown in the standard bolt chart.
1. INSTALL REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY
a. Connect the connector.
b. Install the switch with the bolt.
2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL