RAV4 4WD V6-3.5L (2GR-FE) (2006)
Engine Control Module: Service and Repair
Removal and Installation
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt
pretensioner activation.
2. REMOVE AIR CLEANER CAP
3. REMOVE AIR CLEANER CASE
4. REMOVE ECM
a. Remove the 3 bolts of the ECM bracket.
b. Disconnect the 2 ECM connectors.
NOTE: After disconnecting the connector, make sure that dirt, water and other foreign matter does not contact the connecting part of the
connector.
1. Raise the 2 levers while pushing the locks on the 2 levers, and disconnect the 2 ECM connectors.
c. Remove the ECM with bracket.