RAV4 4WD V6-3.5L (2GR-FE) (2006)
/Page-711002.png)
1. INSTALL HEATED OXYGEN SENSOR (for Sensor 2)
a. Using SST, install the sensor to the exhaust pipe.
SST 09224-00010
Torque: 40 N.m (408 kgf.cm, 30 ft.lbf) for use with SST
44 N.m (449 kgf.cm, 32 ft.lbf) for use without SST
HINT:
-
Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).
-
Make sure SST and a wrench are connected in a straight line.
b. Connect the sensor connector.
c. Bank 1 Sensor 2:
Install the rear console box.
2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
3. CHECK FOR EXHAUST GAS LEAKS
