RAV4 4WD V6-3.5L (2GR-FE) (2006)
Horn Relay: Testing and Inspection
ON-VEHICLE INSPECTION
1. REMOVE ENGINE ROOM NO. 1 RELAY BLOCK COVER
2. INSPECT INTEGRATION RELAY (UNIT A: HORN RELAY)
a. Using a screwdriver, detach the 2 claws and disconnect the integration relay from the engine room junction block.
HINT: Tape the screwdriver tip before use.
b. Measure the resistance of the integration relay.
If the result is not as specified, replace the integration relay.
3. INSTALL ENGINE ROOM NO. 1 RELAY BLOCK COVER