RAV4 4WD V6-3.5L (2GR-FE) (2006)
a. Connect the intelligent tester (with CAN VIM) to the DLC3.
b. Turn the ignition switch ON.
c. Check for DTCs by following the prompts on the tester screen.
HINT: Refer to the intelligent tester operator's manual for further details.
Without Scan Tool
TOYOTA does not provide a procedure for Reading Trouble Codes Without Scan Tool.
Symptom Related Diagnostic Procedures
PROBLEM SYMPTOMS TABLE
Problem Symptoms Table - Occupant Classification ECU
HINT:
-
Use the table to help determine the cause of the problem symptom. The potential causes of the symptoms are listed in order of probability in the
"Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as
necessary.
-
Proceed to the troubleshooting procedures for each circuit in the table.
Check Passenger Air Bag ON/OFF Indicator
CHECK PASSENGER AIRBAG ON/OFF INDICATOR
a. Turn the ignition switch ON.
b. Check that the passenger airbag ON/OFF indicators come on for approximately 4 seconds, then go off for approximately 2 seconds.
HINT: Refer to the table in the previous step regarding the passenger airbag ON/OFF indicator when approximately 6 seconds have lapsed after
the ignition switch is turned to the ON position.
Component Tests
ON-VEHICLE INSPECTION