RAV4 4WD V6-3.5L (2GR-FE) (2006)
Standard Toe-In (unloaded vehicle)
If the toe-in is not as specified, adjust it at the rack ends.
4. ADJUST TOE-IN
a. Remove the boot clips.
b. Loosen the tie rod end lock nuts.
c. Turn the right and left rack ends by an equal amount to adjust the toe-in to the center value.
d. Make sure that the length of the right and left rack ends are approximately the same.
Standard difference: 1.5 mm (0.059 inch) or less
e. Tighten the tie rod end lock nuts.
Torque: 55.5 Nm (566 kgf-cm, 41 ft. lbs.)
f.
Place the boots on the seats and install the clips.
HINT: Make sure that the boots are not twisted.
5. INSPECT WHEEL ANGLE
a. Turn the steering wheel to the left and right full lock positions, and measure the turning angle.