RAV4 4WD V6-3.5L (2GR-FE) (2006)
/Page-1120004.png)
^
Be careful not to drop the drive shaft.
17. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH
a. Using a brass bar and hammer, set the brass bar against position (1) as shown in the illustration and remove the drive shaft.
NOTICE:
^
Do not damage the oil seal.
^
Do not damage the drive shaft boot.
^
Do not allow the drive shaft to fall off.
b. Squeeze the ends of the snap ring, and remove the snap ring from the bearing bracket.
c. Remove the bearing bracket bolt and remove the front drive shaft from the bearing bracket.
NOTICE:
^
Do not damage the oil seal.
^
Do not damage the boot.
^
Do not allow the drive shaft to fall off.
HINT: If the connection is stiff, use a brass bar and hammer to lightly tap the edge of the inboard joint RH and remove it.
18. FIX FRONT AXLE ASSEMBLY
NOTICE: The hub bearing could be damaged if it is subjected to the vehicle weight, such as when moving the vehicle with the drive shaft
removed. Therefore, if it is absolutely necessary to place the vehicle weight on the hub bearing, first support it with SST.
SST 09608-16042 (09608-02021, 09608-02041)
Disassembly
FRONT DRIVE SHAFT ASSEMBLY (for 4WD)
DISASSEMBLY
