Sequoia 2WD V8-4.6L (1UR-FE) (2010)
Rear Door Exterior Handle: Service and Repair
Reassembly
DOOR / HATCH: REAR DOOR: REASSEMBLY
1. INSTALL CUSHION
(a) Install the cushions onto the door panel.
2. INSTALL REAR DOOR OUTSIDE HANDLE FRAME SUB-ASSEMBLY
(a) Slide the rear door outside handle frame subassembly and engage the claw and install it.
(b) Using a T30 "TORX" wrench, tighten the screw
Torque : 4.0 Nm (41 kgf-cm, 35 in-lbf)
3. INSTALL REAR DOOR OUTSIDE HANDLE FRONT PAD
(a) Engage the 2 claws and install the rear door outside handle front pad.
4. INSTALL REAR DOOR OUTSIDE HANDLE REAR PAD
(a) Engage the 2 claws and install the rear door outside handle rear pad.
5. INSTALL REAR DOOR OUTSIDE HANDLE ASSEMBLY