toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Engine Controls - Non-Linear Acceleration From A Stop|Page 3043 > < Engine Controls - Non-Linear Acceleration From A Stop|Page 3037
Page 1
background image

Engine Control Module: All Technical Service Bulletins
Engine Controls - Non-Linear Acceleration From A Stop

T-SB-0295-10

November 1, 2010

Non-Linear Acceleration from a Stop

Service Category
Engine/Hybrid System

Section
Engine Control

Market
USA

Applicability

Introduction

Some 2010 - 2011 model year Sequoia vehicles with the 1UR-FE (4.6 L) engine may exhibit non-linear acceleration from a stop under certain conditions
of low engine rpm with high engine load. The Engine Control Module/ECM (SAE term: Powertrain Control Module/PCM) logic has been revised to
address this condition. Use the following repair procedure to recalibrate the ECM (PCM).

Warranty Information

APPLICABLE WARRANTY

^

This repair is covered under the Toyota Federal Emission Warranty. This warranty is in effect for 96 months or 80,000 miles, whichever occurs first,
from the vehicle's in-service date.

^

Warranty application is limited to occurrence of the specified condition described in this bulletin.

Engine Controls - Non-Linear Acceleration From A Stop|Page 3043 > < Engine Controls - Non-Linear Acceleration From A Stop|Page 3037