toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 3277 > < Initial Inspection and Diagnostic Overview|Page 3275
Page 78
background image

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

NG --  REPAIR OR REPLACE CAN BRANCH WIRE CONNECTED TO STEERING ANGLE SENSOR (CANH, CANL)

OK --  REPLACE STEERING ANGLE SENSOR  See: Brakes and Traction Control/Antilock Brakes / Traction Control
Systems/Steering Angle Sensor/Service and Repair/Removal

34. CHECK FOR SHORT TO GND IN CAN BUS WIRE (CENTER AIRBAG SENSOR)

(a) Disconnect the H56 center airbag sensor connector.

Initial Inspection and Diagnostic Overview|Page 3277 > < Initial Inspection and Diagnostic Overview|Page 3275