Sequoia 2WD V8-4.6L (1UR-FE) (2010)
Front Door Window Regulator: Testing and Inspection
Inspection
WINDOW / GLASS: POWER WINDOW REGULATOR MOTOR: INSPECTION
1. INSPECT FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH
(a) Check the operation of the regulator motor.
NOTICE:
*
Do not apply voltage to any terminals of the motor, except terminal 2, to avoid damaging the pulse sensor inside the motor.
*
Reset the power window regulator motor (initialize the pulse sensor) after installing the power window regulator motor and
regulator assembly onto the door See: Testing and Inspection/Programming and Relearning/Initialization.
(1) Apply battery voltage to the regulator motor and check the operation of the regulator motor.
OK:
(2) If the result is not as specified, replace the power window regulator motor.
2. INSPECT FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH
(a) Check the operation of the regulator motor.
NOTICE:
*
Do not apply voltage to any terminals of the motor, except terminal 2, to avoid damaging the pulse sensor inside the motor.