Sequoia 2WD V8-4.7L (2UZ-FE) (2003)
/Page-24001.png)
Traction Control Module: All Technical Service Bulletins
ABS/TCS - Zero Point Calibration & Sensor Checks
BRAKES
BR007-06
REVISED
Title:
VSC-RELATED ZERO POINT
CALIBRATION & SENSOR CHECK
Models:
'03 - '06 Sequoia
April 5, 2006
TSB REVISION NOTICE:
^
August 3, 2007: Step 1B of the Calibration Procedure has been updated.
Previous versions of this TSB should be discarded.
Introduction
The following information is intended to clarify the Repair Manual procedures for using the Toyota Diagnostic Tester to perform zero point calibration
and sensor checks after the replacement of any of the following components on 2003 - 2006 model year Sequoia vehicles.
^
Vehicle Skid Control Computer
^
Steering Angle Sensor
^
Master Cylinder Pressure Sensor
^
Yaw Rate Sensor
^
Deceleration Sensor
Zero point calibration of the above sensors must also be performed when replacing or repairing steering related parts and when changing the vehicle's
straight-ahead condition for toe adjustment.
Applicable Vehicles
^
2003 - 2006 model year Sequoia vehicles.
Warranty Information
