Sequoia 2WD V8-4.7L (2UZ-FE) (2003)
/Page-138003.png)
D.
Place the Diagnostic Tester into Signal Check mode under the ABS/VSC menu.
E.
Keep the vehicle in a stationary position on a level surface for 4 seconds or more.
F.
For 2WD models: Press the TRAC OFF switch 3 times within 3 seconds without pressing the brake pedal.
G.
For 4WD models: Press the center differential lock (TRAC OFF) switch 3 times within 3 seconds without pressing the brake pedal.
H.
Check that the VSC buzzer sounds for 3 seconds.
NOTE:
If the VSC buzzer does not sound:
^
Repeat the zero point calibration procedures listed in Step 2.
^
Check the VSC buzzer circuit.
I.
Zero point of master cylinder pressure, yaw rate and deceleration sensor is complete. Go to step 3.
