Sequoia 2WD V8-4.7L (2UZ-FE) (2003)
/Page-859011.png)
a. Place matchmarks on the ring gear and differential case.
b. Remove the 12 ring gear set bolts.
c. Using a plastic hammer, tap on the ring gear to separate it from the differential case.
16. CHECK DIFFERENTIAL CASE RUNOUT
a. Install the differential case in the differential carrier.
b. Using a dial indicator, measure the differential case run out.
Maximum case runout: 0.04 mm (0.0016 inch)
c. Remove the differential case.
17. REMOVE SIDE BEARINGS
Using SST, remove the 2 side bearings from the differential case.
SST 09950-40011 (09951-04010, 09952-04010, 09953-04020, 09954-04010, 09955-04061, 09957-04010, 09958-04011), 09950-60010
(09951-00480)
HINT: Fix the claws of SST to the notch in the differential case.
18. DISASSEMBLE DIFFERENTIAL CASE ASSEMBLY
a. Using a pin punch and hammer, remove the straight pin.
b. Remove the pinion shaft, 2 pinion gears, pinion gear thrust washers, side gears and side gear thrust washers from the differential case.
REPLACEMENT
REPLACE COMPANION FLANGE DUST DEFLECTOR
