Sequoia 2WD V8-4.7L (2UZ-FE) (2003)
10. REMOVE ROOF SIDE RAIL WEATHERSTRIP
Using SST, pull off the roof side rail weatherstrip from front end.
SST 09806-30010
11. REMOVE WINDSHIELD OUTSIDE MOULDINGS
Remove the 8 screws and windshield outside mouldings.
12. REMOVE WINDSHIELD OUTSIDE UPPER MOULDING
Using a knife, cut off the moulding as shown in the illustration
NOTE: Do not damage the body with the knife.
13. REMOVE WINDSHIELD GLASS
a. Push piano wire through between the body and glass from the interior.
b. Tie both wire ends to wooden blocks or similar objects.
HINT: Apply protective tape to the outer surface to keep the surface from being scratched.
NOTE: When separating the glass, be careful not to damage the paint and exterior ornaments. To prevent scratching the safety pad when
removing the windshield, place a plastic sheet between the piano wire and the safety pad.
c. Cut the adhesive by pulling the piano wire around it.
d. Remove the glass.
NOTE: Leave as much of the adhesive on the body as possible when cutting off the glass.