Sequoia 4WD V8-4.6L (1UR-FE) (2010)
Use the same procedure as for the RH side See: Restraint Systems/Seat Belt Systems/Seat Belt/Service and Repair/Front Seat Outer
Belt Assembly/Removal.
6. REMOVE COURTESY LIGHT SWITCH
(a) Using "TORX" socket wrench T30, remove the screw.
(b) Disconnect the connector and remove the courtesy light switch.
Installation
LIGHTING (INT): FRONT DOOR COURTESY SWITCH: INSTALLATION
1. INSTALL COURTESY LIGHT SWITCH
(a) Connect the connector.
(b) Using "TORX" socket wrench T30, install the courtesy light switch with the screw.
Torque : 3.7 Nm (38 kgf-cm, 33 in-lbf)
2. INSTALL LOWER CENTER PILLAR GARNISH
HINT
Use the same procedure as for the RH side See: Restraint Systems/Seat Belt Systems/Seat Belt/Service and Repair/Front Seat Outer
Belt Assembly/Installation.
3. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP
HINT
Use the same procedure as for the RH side See: Restraint Systems/Seat Belt Systems/Seat Belt/Service and Repair/Front Seat Outer
Belt Assembly/Installation.
4. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP
HINT
Use the same procedure as for the RH side See: Restraint Systems/Seat Belt Systems/Seat Belt/Service and Repair/Front Seat Outer
Belt Assembly/Installation.
5. INSTALL REAR DOOR SCUFF PLATE LH
HINT
Use the same procedure as for the RH side See: Restraint Systems/Seat Belt Systems/Seat Belt/Service and Repair/Front Seat Outer
Belt Assembly/Installation.
6. INSTALL FRONT DOOR SCUFF PLATE LH