Sequoia 4WD V8-4.6L (1UR-FE) (2010)
SST : 09332-25010
NOTICE:
When pressing in the universal joint spider bearing, be careful not to damage its lip.
HINT
Use the same installation procedure for the universal joint spider bearing on the opposite side.
(f) Using needle-nose pliers, install new hole snap rings into the snap ring grooves of the yoke.
2. INSPECT PROPELLER SHAFT GREASE FITTING DIRECTION
HINT
When replacing a spider bearing, be sure that the grease fitting hole is facing the direction shown in the illustration.
3. INSPECT UNIVERSAL JOINT SPIDER BEARING See: Testing and Inspection/Component Tests and General Diagnostics/Front Propeller
Shaft Assembly
Disassembly
DRIVE SHAFT / PROPELLER SHAFT: PROPELLER SHAFT ASSEMBLY (for 4WD): DISASSEMBLY
1. INSPECT PROPELLER SHAFT ASSEMBLY See: Testing and Inspection/Component Tests and General Diagnostics/Propeller Shaft Assembly
2. INSPECT UNIVERSAL JOINT SPIDER BEARING See: Testing and Inspection/Component Tests and General Diagnostics/Propeller Shaft
Assembly
3. REMOVE REAR PROPELLER SHAFT UNIVERSAL JOINT SPIDER
HINT
Use the same removal procedure for both the front and rear propeller shaft universal joint spiders.